One general purpose motor with direct mount hydraulic pump for operation on 220/440 volts, 3 phase, 60 hertz, with 110 volt control circuit (please specify voltage).
STANDARD EQUIPMENT on each Chicago Hydraulic Power Bending Brake:
- Removable Nose Bar.
- Bolted Bottom Bar.
- Compact Hydraulic Power Unit.
- Angle Bar.
- Insert Bar.
- Oil Level Sight Gauge.
Control Panel Features:
- On/Off Key Selector Switch.
- Bending Leaf Up/Down Pushbuttons.
- Clamp/Unclamp Pushbuttons.
- Motor Start Pushbutton.
- Emergency Stop Push Button.
- Automatic Cycle Push Button.
Electric Foot Switch – Clamps and unclamps Top Leaf. Allows operator mobility when loading and unloading material.
Bend Angle Dial Adjustment – Adjustable cam and scale that read in degrees, actuates an electric limit switch for bend angle control and repeatability of bends.
Material Thickness Dial Adjustment – Reference scale for speedier set up when adjusting clamping pressure.
Back Gauge – 25 1/2″ travel, rack and pinion type gauge with hand wheel adjustment on right side of machine. Inch/Cm scales.